How are you making services remotely accessible?
I need help figuring out where I am going wrong or being an idiot, if people could point out where...
I have a server running Debian 12 and various docker images (Jellyfin, Home Assistant, etc...) controlled by portainer.
A consumer router assigns static Ip addresses by MAC address. The router lets me define the IP address of a primary/secondary DNS. The router registers itself with DynDNS.
I want to make this remotely accessible.
From what I have read I need to setup a reverse proxy, I have tried to follow various guides to give my server a cert for the reverse proxy but it always fails.
I figure the server needs the dyndns address to point at it but I the scripts pick up the internal IP.
How are people solving this?
You are viewing a single comment
The easiest and quickest way thats still safe is to just use tailscale.
Its a zero config VPN that you can install on all your devices. I've been using it for quite some time now and I'm still fascinated by how easy to use it is.
I would want to go that appros but it feels very inconvenient having to connect to VPN every time I want to check something, also the battery drain if I stayed connected all the time
I’ve been using Tailscale for about 2 months now. It has a VPN-on-demand setting that I keep enabled. That way, anytime I am not on my local WiFi, it automatically connects the VPN. According to my battery health settings, Tailscale has used 5% of my battery in the last 10 days. And I am even using a Mullvad exit node, which would use even more battery.
Where is VPN in demand setting?
On iOS, I tap on my profile in the upper right, and the VPN-on-demand setting is right below my account.
Not sure is it same, I don't use tailscale, but using pure wireguard. In my experience battery drain is not even noticable, but staying connected is not smooth as I'd like. I tried to keep active VPN all the time, but then sometimes I just notice my internet is not working ( I have disable or restart VPN connection). It could be issue with my phone (Android), missconfig or something else, but I switched to manually enabling VPN every time I need it. Not amazing, but few clicks every now and then is more than acceptable for my use case
No significant battery drain for me, and I use it a lot, almost all the time.
Yea, it's a little drain, just nothing to worry about.
Or Twingate. It works very well for me
I found Tailscale/Headacale way more difficult to setup than Wireguard.
Enable Funnel and the Tailscale client isn't required.