Homemade induction heater is a win!

Smokeydope@lemmy.world to Trees@lemmy.world – 56 points –

Managed this rig up a homemade induction heater from a 10$ board off amazon +7$ cigarette plug terminal cable

Induction heater is for my dynavap, the commercial ones are quite expensive and I figured it would be a cheap and easy project to make one up

I made a quick YouTube video showing the IH off :)

11

Jesus, stoner engineering really stepped up it's game.

Pepperidge Farm remembers when clever was an apple and a lighter.

Half of us would die trying to use that, but glory to glorzo if it works for ye but not for me.

I pretty much only buy single apples when I am planning to use them as a pipe. That is the best way to smoke a bowl. And if you're not a scaredy cat, it becomes a baked apple treat when you're done.

looks at traditional stoner equipment "We have the technology... We can rebuild them. Make them hit faster, stronger, cleaner."

This post was a journey for me scrolling by.

Pic: this is drugz?

Title: this is not drugz

Sub: this is drugz!

How powerful is the board? i've always wanted to melt metal with an induction coil.

The board is rated for up to 12v10a so 120 watts. Its able to heat up the dynavap to combusting temps in about 10 seconds so I wouldn't doubt its able to melt thin wire in short order. For my purposes it's actually almost too powerful so either need to lower the turns in coil or add a potentiometer on to the circuit

Or get a housing for the unit and a glass slide for the inside of the coil. By the time you do that it will be pretty dialed in. Source: I’ve built a few

Do you have any good suggestions for what I can do for housing unit? Was thinking of getting a little wood cigar box from local smoke shop. Glass slide is a good idea. I actually do have it pretty dialed in now after a week of daily use took a bit of time and practice.